Soil tests provide the best way to determine pre-plant requirements for lime and fertilizers. For perennial fruit crops, leaf tissue or petiole analysis are the best ways to determine nutrient status for established crops. With the information from these tests, growers can make informed decisions about fertilizing and liming small fruit crops to achieve optimum yield and quality and to safeguard water quality in a cost-effective manner. Following is a list of soil test laboratories in New England. It is best to use local labs because they are calibrated for local soils and recommendations are tailored to New England conditions.
Soil Testing Labs of New England
soil testing (1), leaf tissue analysis (2), compost testing (3), manure testing (4)
CONNECTICUT
UConn Soil Nutrient Analysis Lab (1, 2)
6 Sherman Place, Unit 5102
Storrs, CT 06269-5102
Telephone: 860-486-4274
Email: soiltest@uconn.edu Website: http://www.soiltest.uconn.edu/
The Connecticut Agricultural Experiment Station (1)
Gregory Bugbee, State Laboratory
123 Huntington St., P.O. Box 1106
New Haven, CT 06504
Telephone: 203-974-8521
Email: Gregory.Bugbee@ct.gov Website: https://portal.ct.gov/CAES/Soil-Office/Soil-Office/Soil-Testing-Offices-Instructions
MAINE
The Analytical Laboratory and Maine Soil Testing Services (1,2,3,4)
5722 Deering Hall, Room 407
Orono ME 04460-5722
Telephone: 207-581-3591
Email: hoskins@maine.edu Website: https://umaine.edu/soiltestinglab/
MASSACHUSETTS
UMass Soil & Plant Tissue Testing Laboratory (1,2)
203 Paige Laboratory/UMass
161 Holdsworth Way
Amherst MA 01003-9302
Telephone: 413-545-2311
Email: soiltest@umass.edu Website: https://ag.umass.edu/soiltest
Durham NH 03824
Telephone: 603-862-3200
Email: soil.testing@unh.edu Website: https://extension.unh.edu/agriculture-gardens/pest-disease-growing-tools/soil-testing-services
VERMONT
UVM Agricultural & Environmental Testing Lab (1,3,4)
262 Jeffords Hall, 63 Carrigan Drive, UVM
Burlington VT 05405
Telephone: 802-656-3030, 800-244-6402
Email: AgTesting@uvm.edu Website: https://www.uvm.edu/extension/agricultural-and-environmental-testing-lab
http://www.blinc.com/agriculture-analysis
Woods End Research Lab, Inc. (1,3)
290 Belgrade Rd., P.O. Box 297
Mt. Vernon, ME 04352
Telephone: 207-293-2457
Email: lab@woodsend.com Website: https://woodsend.com/
Although soil samples can be taken any time, many prefer to take samples in summer or fall because this allows time to apply any needed lime, plan a fertility program and order materials well in advance of spring planting. Avoid sampling when the soil is very wet or soon after a lime or fertilizer application. If a field is uniform, a single composite sample is sufficient. A composite sample consists of 10 to 20 sub-samples taken from around the field and mixed together. To obtain sub-samples, use a spade or a soil probe to take cores or thin slices of soil representing the top 6” to 8” of soil. Put these sub-samples into a clean container and thoroughly mix. Take about one cup of the mixture, dry it at room temperature, put it in a zip lock bag and tightly close it. Label each sample on the outside of the bag. To get accurate recommendations, make sure to download and fill out sample submission forms from the lab where samples will be sent.
In many cases, fields are not uniform, due to uneven topography, wet and dry areas, different soil types, or areas with varying previous crop and fertilizing practices. In such cases, the field should be subdivided and composite samples tested for each section.
Soil testing laboratories vary somewhat in their services and prices. Soils should be tested for organic matter content every two or three years. Be sure to request this if it is not part of the standard test. For more information, check with your state’s laboratory or Extension Specialist.
Cation exchange capacity (CEC) is a measure of the soil’s ability to retain and supply nutrients, specifically the positively charged nutrient ions called cations. These include the cations calcium (Ca2+), magnesium (Mg2+), potassium (K+), ammonium (NH4+), and many of the micronutrients. Cations are attracted to negatively charged surfaces of clay and organic particles called colloids. CEC is reported in units of milli-equivalents per 100 grams of soil (meq/100 g) and can range from below 5 meq/100 g in sandy, low organic matter soils to over 15 meq/100 g in finer textured soils and those high in organic matter. Low CEC soils are more susceptible to cation nutrient loss through leaching, and may not be able to hold enough nutrient cations for a whole season of crop production.
The cations calcium (Ca2+), magnesium (Mg2+), potassium (K+), hydrogen (H+) and aluminum (Al3+) account for the vast majority of cations adsorbed on the soil colloids in New England soils. Hydrogen (H+) and aluminum (Al3+) are considered acidic cations because they tend to lower soil pH while calcium (Ca2+), magnesium (Mg2+), and potassium (K+) are considered basic cations and have no direct influence on soil pH. Base saturation is the portion (expressed as a percentage) of the soil’s cation exchange capacity occupied by calcium (Ca2+), magnesium (Mg2+), and potassium (K+). At one time, many labs provided fertilizer recommendations to achieve very specific ideal potassium, calcium, and magnesium saturation ratios. This approach was never well supported by data. Research conducted over the last several decades indicates that an ideal basic cation ratio does not exist and fertilizing to achieve a prescribed level of potassium, calcium, and magnesium saturation is unjustified. Still, base saturation can provide useful information. Your report will include the base cation saturation values observed for your sample and the ranges typically observed in New England soils. When base saturation is well outside of these ranges it is typically associated with deficient or excessive potassium or very acidic or alkaline soil conditions. Following the fertilizer and lime recommendations provided with your report will typically result in base saturation values within normal ranges.
One of the most valuable pieces of information you can get from soil testing is a measure of the soil pH. Soil pH is an indicator of the soil’s acidity which is a primary factor controlling nutrient availability, microbial processes, and plant growth. A pH of 7 is neutral, less than 7 is acidic, and greater than 7 is alkaline. Maintaining proper soil pH is one of the most important aspects of soil fertility management. When the soil is acidic, the availability of nitrogen, phosphorus, and potassium is reduced, and there are usually low amounts of calcium and magnesium in the soil. Under acidic conditions, most micronutrients are more soluble and are therefore more available to plants. Under very acidic conditions aluminum, iron, and manganese may be so soluble they can reach toxic levels. Soil acidity also influences soil microbes. For example, when soil pH is low (below 6), bacterial activity is significantly reduced. Acidic soil conditions also reduce the effectiveness of some herbicides.
When soil pH is maintained at the proper level, plant nutrient availability is optimized, solubility of toxic elements is minimized, and beneficial soil organisms are most active. While most plants grow best in soil with a pH between 6 and 7, there are some notable acid-loving exceptions, such as blueberry, which performs best in soils with a pH near 5.
Due to the climate and geology of New England, soils here tend to be naturally acidic (4.5-5.5).The most effective way to increase soil pH is to apply agricultural limestone. The quantity of lime required is determined by the target pH (based on crops to be grown) and the soils buffering capacity. Buffering capacity refers a soil’s tendency to resist change in pH. Soil pH is a measure of active acidity, based on the concentration of hydrogen ions (H+) in soil solution, and is an indicator of the current soil condition. When lime is added to a soil, active acidity is neutralized by chemical reactions that remove hydrogen ions from the soil solution. However, there are also acidic cations (H+ and Al3+) adsorbed on soil colloids (the CEC) which can be released into the soil solution to replace those neutralized by the lime. This exchangeable acidity, which is reported in units of meq/100 g, is directly related to the quantity of lime required to increase the pH from its current level to the target level determined by the selected crop. Soils such as clays or those high in organic matter have a high cation exchange capacity (CEC) and a potential for large amounts of exchangeable acidity. These soils are said to be well buffered. Buffer pH is a measure of reserve acidity and is used by the soil testing laboratory to estimate buffering capacity and lime requirement. Low buffer pH readings indicate high amounts of reserve acidity, and therefore, high amounts of lime will be recommended.
Occasionally soil pH must be lowered, because either the plant requires acid soil or the soil was previously over-limed. Incorporating elemental sulfur (S) is the most effective way to lower soil pH. Once applied, the sulfur oxidizes to sulfuric acid. Applying 5 to 10 lbs. of sulfur per 1000 sq. ft. will lower the pH of most New England soils by approximately half a unit. Use the lower rate for very sandy soils. No more than 15 lbs. of sulfur per 1000 sq. ft. should be applied at any one time. Retest the soil after 4 to 6 months to determine if more sulfur is needed.